#1
|
|||
|
|||
Ayre KX-5/20 by-pass release
For surround and cable HDMI goes to a Bryston SP3 that returns balanced LR to a by-pass input of the KX-5. And that works well. But after using that setup, there was no audio with Roon to the QX-5 though the QX-5 displayed the signal rate and the KX-5 displayed QX-5. I disconnected AC to both the KX-5 and SP3 then reconnected only the KX-5 to no avail. The solution seems to be selecting a non-by-pass input of the KX-5 before standby.
|
#2
|
|||
|
|||
Sorry in advance for the thread hijack. My preamp has had the AC message kick in a lot the last two days, indicating low voltage. I'm in DC, and we're in the midst of a heat wave, so perhaps that could be the reason for unstable AC. My AC message is not accompanied by the red light and pressing the right-side button on the faceplate returns the preamp to normal. I haven't added anything to the circuit on which my system uses either. Any insight would be appreciated. Thanks.
__________________
|
|
|
Audio Aficionado Sponsors | |