Trying to source a new pulley for my Ref. Motor

[ehoove]

I am trying to source a new pulley for the Reference Motor that drives my Solution Table. The motor was an upgrade as was the CMB bearing and other items. The Delrin pulley adjustment screws are chewed up making it difficult to adjust the pulley properly.

If I cannot source one the alternative is to replace the screws if I can get the chewed up ones out, or have a new pully machined.

Regards,
Jim

[Formerly YB-2]

Jim - Assume you've been in contact with Clearaudio to ask about same?

[ehoove]

Yes, and they directed Musical Suroundings to contact me which they have.
Regards,
Jim

[djcxxx]

I’ve had good luck with Musical Surroundings in the past w/adjusting my TTS-3 cartridge arm. They should come through for you.

[ehoove]

Clear Audio in Germany had MS contact me in 48 hrs. :^) However Jim Pendelton owner of Osage Audio Products LLC contacted MS directly and sourced 3 new Delrin screws for my pully, and I will try that first. (The previous owner had chewed up the screw heads where they could no longer be adjusted)

A big shout out to Jim Pendleton for going above and beyond for a small item needed to hopefully correct my long standing issue!
Regards,
Jim

[ehoove]

Received the new screws today and the pulley problem is solved! The table is back up and running as it should!
Very Pleased,
Jim