#31
|
|||
|
|||
Such a lot of fine tuning and burn in to be done, you are going to be busy for some time. You will enjoy every minute of it
|
#32
|
|||
|
|||
Congrats. My favorite speakers.
__________________
Wilson Alexia V, ARC Ref 160M MkII,Ref 40,Ref Phono2SE, Shunyata Triton3, Typhon, Sigma PCs, ICs & SCs, Spectral SDR4000SV (w MIT IC), Belcanto PL1, Oppo 205, Marantz 2270 (tuner only):AudioDesk and VPI record cleaners, Furutech Demag & Destat; Stillpoint Apertures, TechDas AF 3S Premium with SAT CF9 and Kuzma 4pt 9" arms, Lyra Atlas Lambda SL, Dynavector XV1-t stereo and XV1-s mono carts, Miyajima mono, Shure V15VxMR, |
#33
|
|||
|
|||
Better late than never
|
#34
|
|||
|
|||
They look great! Now, enjoy the music...
__________________
Mike |
#35
|
|||
|
|||
Have you removed the protective warp right away? I thought WA recommend it should be left on for a few weeks to wait for the paint to completely cured before removal.
Is it the final speaker position or more fine tuning is needed? It seems too close to back wall to fully perform. Any plan to remove the wheels and put the spikes on? |
#36
|
|||
|
|||
Film and setup
Quote:
I agree the speakers are much much closer to the walls than I had anticipated, but the current position is where the installer thought they sounded the best. There is still fine tuning that needs to be done and they are scheduled to come out for final positioning within the next week. I am going to mark where they are now (just in case) but try pulling them away from the walls and see what happens. They didnt follow the process as it was described in the manual, but I also have a fairly limited area to have them set up. I should also state that I had the TV pulled away from the wall in the pictures as I was screwing around with different interconnects. Once the final positioning is figured out, the wheels will be coming off. I chose silver spikes in case anyone was wondering. |
#37
|
||||
|
||||
They didn't "voice" your speakers properly. I just went thru an install of Wilson Maxx 3 speakers and am now familiar at the measuring, moving, and remeasuring. There should be a change each time it is done. The lower drivers are firing into the sides of your cabinet that supports your monitor. That alone will cause timing issues.
__________________
Source Esoteric K-01X Preamp Audio Research REF 10 Amplifier D'Agostino Progression monoblocks Speakers Wilson Audio Maxx 3 Cables Transparent Reference Gen 5 Equipment rack and amp stands HRS Power conditioning Transparent Power outlets GTX-D(G) Gold-Plated duplex receptacles dedicated 20 amp lines. |
|
|
Audio Aficionado Sponsors | |