#11
|
|||
|
|||
I replaced a Marantz SA11 S3 with an SA10 in my system consisting of a McIntosh C48, MC452, Bryston Mini T's and a REL Gibraltar G2. In my opinion it is the finest sounding component that I've ever bought.
|
#12
|
|||
|
|||
duffy, any comments on the transport and its operation?
|
#13
|
|||
|
|||
Hi duffy1212, I have the SA11S3 in one system. Regarding SACD performance I have no comments, excellent reproduction. However Red Book CD is of lower performance. How would you compare SA 10 to Sa113S on Red Book CD performance only? Many thanks
|
#14
|
|||
|
|||
Regarding the transport, I have had no issues with it. The indentation in the disk drawer is a little shallow, so a little more care is needed to seat the CD properly. If its not quite right it will give you a "no disk" message. The performance with Red Book cd's is where I've noticed the biggest difference. PCM is up converted to DSD in a manner which I believe is similar to how the PS Audio Direct Stream DAC functions. I have to admit that I am not that knowledgeable about the particulars. I do know that it sounds fantastic.
|
#15
|
|||
|
|||
Good to know
|
#16
|
|||
|
|||
The Marantz PM 10 is a Real Game Changer! This is a Class H amp!
https://translate.google.com/transla...25&prev=search Last edited by Rick721; 11-03-2017 at 06:53 PM. |
#17
|
||||
|
||||
I'm bafled that the article described the PM10 as a digital switching amp. In the next breath it is said to have a switching power supply. This implies, to me, bridged analog amplification with a switching power supply???????????
__________________
System: ML:5206,5302 Serafino's Nordost Lumin U1 RM15 |
#18
|
|||
|
|||
The Marantz PM-10 incorporates switching power amplification described in more detail as follows:
"For the first time in Marantz history, the new flagship uses switching power amplification to deliver 200 watts RMS into an 8-ohm load, 400 into 4 ohms. Marantz eschews the designation of “Class D” for this amplifier because to many audiophiles that term always connotes a digital process, which simply isn’t true. The PA-10 is driven by a differential analog signal, a highly linear switching modulator operating at 450kHz. There are separate power supplies for the preamplifier section and for each of the power amp channels. With the goal of achieving the greatest possible noise rejection throughout the signal path, the topology is fully balanced from input to output. Line-level single-ended inputs are provided as well, though it’s hard to imagine many purchasers will be using them." |
#19
|
||||
|
||||
Sounds a bit like the PWM power supply used by Sony in their wonderful little TA-N86 amps back in the day. They used 400mHz Motorola power transistors to get 70wpc class A/B or 16wpc Class A. Sucker ran so hot that it almost always fried the 85C caps in a couple of years. Replacing with 105C rated caps solved the problems. Am guessing Marantz has solved this problem all ready.
__________________
Glenn... Canton Reference 9 Clearaudio SM Pro Focal Bathys JLA 10" Dominion Kuzma Stabi S w/MC & MM Magnepan 1,7i McIntosh MA8950 & MR88 Oppo 203 Roon Nucleus Rose Hifi RS150B Shunyata Gemini-4 Sony ST-A6B, TA-F6B, ST-J75 & PS-X75 Sorane SA1.2 & TA-1L Stillpoints LP1v2 WW Pt, Au & Ag |
#20
|
||||
|
||||
Marantz PM-10 generates almost no heat powering Klipsch Cornwall III speakers at medium volume levels for hours at a time.
|
|
|
Audio Aficionado Sponsors | |