#21
|
|||
|
|||
My pleasure and thank you and others, again, for the kind words....
|
#22
|
||||
|
||||
Legacy Wavelet II
I’ve tried feeding my wavlet v1 all those ways as well. Straight digital signal into the wavelet from a dCS network bridge bested an aurender n100 by a large margin but now my favorite is the bartok into a McIntosh pre amp then that analog signal into the wavelet. I also tried the bartok into the wavelet using the volume control from the bartok. All of these configurations sounded incredibly good and I have always enjoyed going back and forth for months at a time. That wavelet is quite versatile.
Can’t wait for the V2.
__________________
PS Audio P10, dCS Bartok, McIntosh C1100, Legacy Wavelet, McIntosh 452, Legacy Aeris Last edited by Rick U; 01-13-2022 at 01:20 PM. |
#23
|
|||
|
|||
Great feedback, thanks Rick,...+1 !!!
|
#24
|
|||
|
|||
Currently have wavelet with Legacy V. I am using the ssuppliedpower supply. If I am to substitute the wall wart, what voltage and current does the Wavelet require and where do I get the appropriate power cable termination? I have a Keces liner power supply I could likely use.
Intend to upgrade to the Wavelet II. With the Wavelet II are you hearing more transparency and microdynamics? |
#25
|
|||
|
|||
Legacy Wavelet II
Anticipating upgrading Wavelet for my Legacy V. What voltage and current does the Wavelet II require. I have a Keces linear power supply which I could use. Where do you get the proper termination for the power cord.
Have you noted improved microdynamics and resolution with the new Wavelet? |
#26
|
||||
|
||||
I can’t remember what the voltage is off the top of my head. Alex at UpTone audio guided me and made the umbilical cord. You can contact him through their site. Also the wall wart should have the specs on it.
__________________
PS Audio P10, dCS Bartok, McIntosh C1100, Legacy Wavelet, McIntosh 452, Legacy Aeris |
#27
|
|||
|
|||
This is an excellent thread. Very informative about Legacy. Mark is a true expert on Legacy and audio in general as are you all.
Best Charles |
#28
|
|||
|
|||
Charles,
Thank you very much Charles,...it's just passion for the hobby and desire to share what I've learned from much smarter folks over the years. |
#29
|
|||
|
|||
Quote:
Please verify all info accordingly, especially the amp spec. Check with your LPSU maker for his type of connector (HDPLEX uses XLR3 and how the pin mapping must be done to connect with the correct XLR5 (5-pin) power connector on back of Wavelet. Last edited by SCAudiophile; 01-14-2022 at 10:36 PM. |
#30
|
|||
|
|||
Quote:
|
|
|
Audio Aficionado Sponsors | |