NR Cables for Source Components with a Conditioner: Why?

[SackATK]

Originally Posted by Craig_B

My Delta v2 NRs arrived yesterday and I am somewhat in a bind trying to figure out how to best secure the cable to my Mc MA9000 that is on the top shelf of my SolidSteele rack (I goofed in assuming the MA9000 would fit the middle or bottom shelves - it will not without having to remove the feet which I do not what to do - and you can see it also extends out past the end of the shelf). I have used the Audio Bastion risers/supports in my theater rack and will do so for the components in this setup, but can't for the MA9000 that sits on the top and extends out past the back of the shelf. The cable is pretty loose and the weight causes it to sag. Any suggests on how I might secure it in this particular scenario?

Thanks.

In these cases, I use self-fusing silicone tape wrapped around the part of the connector that's inserted into the inlet. Usually one wrap is good enough to create a snug sagless fit. This tape also has no residue and can easily be removed.