Quote:
Originally Posted by jmw31
I was looking at REL's. This is the response I go from customer service regarding mono blocks:
"Thank you for your interest in REL. If planning to use a single REL with monoblocks, you must use a low level RCA connection via the preamp instead of high level.
If connecting a pair of REL's via high level to the MC2301's, the BLACK wire should be left disconnected from a negative speaker terminal. You would connect the RED and YELLOW wires of each sub to the 8 ohm positive tap on each amp for best output.
Please let us know if there is anything else at all that we can assist with, and thank you again for considering our products."
|
Thanks. Per REL, if there is hum, you can connect the black wire to the bolt/screw in the chassis of each of the monoblocks.
__________________
Amps: Mc611s; Bryston 9BST Speakers: B&W 802D3, HTM1D3, B&W SCMs, 2x REL Carbon Special + Analysis Plus REL SpeakOn cable; Pre-Amp: C2700; Processor: Marantz 8805A Sources: Aurender N20; PSA Directstream DAC; JVC RS2000; Stewart Screen Cabaret with StudioTek 130 G4; Oppo UDP-205; Power & Cables: Taralabs bi-wire; WW XLR Silver Eclipse 8; WW Silver Starlight 7 Coax; Denali 6000T, Shunyata Alpha, Delta and Venom.
|