AudioAficionado.org

AudioAficionado.org (https://www.audioaficionado.org/index.php)
-   Clearaudio (https://www.audioaficionado.org/forumdisplay.php?f=135)
-   -   Trying to source a new pulley for my Ref. Motor (https://www.audioaficionado.org/showthread.php?t=49477)

ehoove 02-02-2021 06:25 PM

Trying to source a new pulley for my Ref. Motor
 
I am trying to source a new pulley for the Reference Motor that drives my Solution Table. The motor was an upgrade as was the CMB bearing and other items. The Delrin pulley adjustment screws are chewed up making it difficult to adjust the pulley properly.

If I cannot source one the alternative is to replace the screws if I can get the chewed up ones out, or have a new pully machined.

Regards,
Jim

Formerly YB-2 02-02-2021 06:37 PM

Jim - Assume you've been in contact with Clearaudio to ask about same?

ehoove 02-03-2021 08:19 PM

Yes, and they directed Musical Suroundings to contact me which they have.
Regards,
Jim

djcxxx 02-04-2021 04:59 PM

I’ve had good luck with Musical Surroundings in the past w/adjusting my TTS-3 cartridge arm. They should come through for you.

ehoove 02-07-2021 02:53 PM

Clear Audio in Germany had MS contact me in 48 hrs. :^) However Jim Pendelton owner of Osage Audio Products LLC contacted MS directly and sourced 3 new Delrin screws for my pully, and I will try that first. (The previous owner had chewed up the screw heads where they could no longer be adjusted)

A big shout out to Jim Pendleton for going above and beyond for a small item needed to hopefully correct my long standing issue!
Regards,
Jim

ehoove 02-12-2021 02:11 PM

Received the new screws today and the pulley problem is solved! The table is back up and running as it should!
Very Pleased,
Jim


All times are GMT -4. The time now is 06:25 AM.

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
©Copyright 2009-2023 AudioAficionado.org.Privately owned, All Rights Reserved.