AudioAficionado.org

AudioAficionado.org (https://www.audioaficionado.org/index.php)
-   Ayre (https://www.audioaficionado.org/forumdisplay.php?f=36)
-   -   Ayre KX-5/20 by-pass release (https://www.audioaficionado.org/showthread.php?t=49496)

dbphd 02-06-2021 08:26 AM

Ayre KX-5/20 by-pass release
 
For surround and cable HDMI goes to a Bryston SP3 that returns balanced LR to a by-pass input of the KX-5. And that works well. But after using that setup, there was no audio with Roon to the QX-5 though the QX-5 displayed the signal rate and the KX-5 displayed QX-5. I disconnected AC to both the KX-5 and SP3 then reconnected only the KX-5 to no avail. The solution seems to be selecting a non-by-pass input of the KX-5 before standby.

will 06-08-2021 10:50 AM

Sorry in advance for the thread hijack. My preamp has had the AC message kick in a lot the last two days, indicating low voltage. I'm in DC, and we're in the midst of a heat wave, so perhaps that could be the reason for unstable AC. My AC message is not accompanied by the red light and pressing the right-side button on the faceplate returns the preamp to normal. I haven't added anything to the circuit on which my system uses either. Any insight would be appreciated. Thanks.


All times are GMT -4. The time now is 07:23 AM.

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
©Copyright 2009-2023 AudioAficionado.org.Privately owned, All Rights Reserved.